
Viking oven & stove repair in Los Angeles
10%
off labor
when you book online
Labor only. Parts are not discounted.
Tell us what broke
We repair Viking professional ranges in kitchens across Los Angeles, both all-gas and dual-fuel. Most calls involve ignition, meaning a burner that won't catch, one that keeps clicking, or an oven that's slow to come up to heat. The gas hardware on these is built to last, so the fix is usually a part plus labor, and same-day visits come inside a 2-hour slot.
Parts on a Viking oven & stove: The gas side runs on commercial-style hardware. Spark modules, igniters and gas valves still fit ranges two decades old, so most of the bill is labor. Knobs, doors, trim and any finished piece come only through Viking's distribution channel, and those parts slow a job down. Very little of it sits on a shelf in LA. Our same-day visit still stands, but a part may take longer to arrive.
How the visit goes: We confirm which Viking it is before ordering anything, since a 5 Series, a 7 Series and a Tuscany share fewer parts than people expect. Then we test the ignition path in order, from spark at the burner to igniter current at the oven to whether the safety valve opens. If the fault is a door, hinge or trim piece, you'll know on the first visit that it comes through Viking.
- Diagnostic
- $70. It comes off the bill when you approve the repair. If you decline, it is all you pay.
- Parts
- Spark module, burner igniter, oven igniter, gas valve and bake/broil element (dual-fuel). Common ones ride on the van, the rest are ordered by model number.
- Warranty
- 90-day parts & labor on the work we did.
You approve the flat number before anything is opened.
Common Viking oven & stove problems
Below are the Viking range faults people call about, each paired with its likely part and the test we run before quoting.
- Burners won't light, or keep clicking once lit. Usually the igniter has worn or the spark module has shorted, and one faulty switch can set every burner clicking, so we isolate that switch first.
- The oven heats slowly or never gets there. On gas, a weak igniter can glow yet pull too little current for the safety valve, so we put a clamp meter on it before anything else.
- Bakes come out uneven, or the oven runs hot or cool. We check the real temperature with a probe, then the sensor, and on a dual-fuel range the bake element as well.
- A weak or yellow flame on a sealed burner. Crusted ports or a burner cap knocked off its seat are the common reason, so we clean and reseat before suspecting the valve.
- A smell of gas. Leave knobs and light switches alone, open a window and shut the appliance valve. If it's strong, get outside, call the gas utility, and only then call us.
Viking oven & stove lines we see in LA
Most Viking ranges in LA kitchens are Professional 5 Series, and the regular work on those is oven igniters, spark modules and the sealed burner assemblies. The 7 Series is built heavier and lays its controls out differently. Owners tend to assume a 5 Series part will fit it, and often it won't, so we check before ordering. Tuscany is the Italian-built one, trimmed in brass, and its burners and valves belong to it alone. Dual-fuel versions put a gas top over an electric oven, which means the oven side runs on bake and broil elements, not a gas igniter.
More Viking repairs
The same flat pricing and 90-day warranty on every Viking appliance in the house.
Where to go next
Oven & stove repair on other brands
Oven & stove repair on every other brand we service.
Independent repair service. We are not affiliated with, authorized by or trained by Viking. Brand and series names are the trademarks of their owners, used here to describe the equipment we work on. Manufacturer parts are sourced for each job rather than held as brand inventory.
Repair or replace a Viking oven & stove
A Viking range is worth fixing well past fifteen years. Its gas hardware is mechanically simple and holds up, and the body is built for decades of cooking. The parts are what push the bill up, since Viking prices its own pieces high and a few can only be ordered. If yours is a wall oven, reaching its board or hinges means two people lifting it clear of the cabinet. Replacing the oven igniter on a gas model typically comes in around $190-$320. The oven & stove repair cost guide walks through the parts and the labor behind each end of the range.
Viking oven & stove questions
Why won't my Viking burners stop clicking?
Some clicking while a burner lights is normal, since the igniters on these spark together. Clicking that won't stop after the flame catches is a fault. Usually one spark switch has failed or the module is shorting. A cracked electrode is the cheaper suspect, so we test it before anyone replaces the module.
Why does my Viking oven take forever to heat, or never get hot?
On a gas oven it's usually a tired igniter. It can glow bright and still pass too little current, so the safety valve stays shut and no gas reaches the burner. We read that current with a clamp meter instead of trusting the glow. On a dual-fuel model the oven is electric, and we test the bake element and the sensor.
Why does a Viking repair sometimes need a second visit?
Parts. Common ignition parts may be on the van, but doors, knobs and finished trim come only through Viking's distribution, and there aren't many Viking ranges in LA compared with mass brands, so local stock is thin. The first visit gets you a diagnosis and the flat price, and we come back when the part is in.
What do I do if my Viking smells like gas?
Treat it as a safety call first. Don't light anything or touch the light switches, open a window and close the gas valve at the range. With a strong smell, get everyone out and phone the gas utility from the street. Once they've cleared it, call us and we'll look at the valves and burners.
Book the Viking oven & stove repair
Same-day visits across Los Angeles, common parts on the van, the rest ordered by model number, and a flat price you approve before the oven & stove is opened.










