Ice maker repair in Encino

Most jobs $150–$400Same-day, 2-hour arrival window

10%

off labor

when you book online

Labor only. Parts are not discounted.

Tell us what broke

We'll call or text about this repair. Nothing else.

State registered and insured Same-day, 2-hour window Diagnostic credited

Encino homes south of Ventura sit on big lots with kitchens remodeled around built-in refrigerators and double ovens. We handle ice maker repair across Encino for a flat quote from $150, and most jobs finish on the first visit.

Ice makers here are fed by a line run during a remodel, usually picked up from a manifold at the island rather than from the nearest stop. That adds length and one more fitting between the supply and the valve. A valve that no longer seats cleanly then weeps into the fill tube between cycles. The tube freezes, and the next fill lands on top of ice that is already there.

About Encino

Encino gets LADWP water from the Los Angeles Aqueduct, local groundwater and the State Water Project, and in 2025 those Valley sources averaged 103, 115 and 140 mg/L of hardness. The bigger strain on appliances is heat, because the nearby Van Nuys Airport station averages a 93.1°F high in August and 14.7 days a year at 100°F or more, when refrigerators and freezers run almost nonstop. Across ZIP codes 91316 and 91436, 75.1 percent of homes were built before 1980 and 24.1 percent date from the 1950s, so many kitchens and laundry rooms still have older supply lines, valves and wiring. Most households own their home, 59.3 percent, and 54.0 percent of homes are detached houses. LADWP rebates include up to $500 on an efficient washer through SoCal Water$mart.

What it costs

Ice maker repair pricing

Typical range $150 to $400

Other repairs we do in Encino

Same crew, same flat quote before anything is opened. What moves the number on this job is set out in the cost guide.

What breaks most often in Encino

One fused lump in the bin instead of separate cubes, caused by a fill tube frozen solid by a valve that drips after it closes.

  1. Built-in columns south of Ventura need gasket and defrost work, not a swap, and the heat here pushes them hard.
    from $200
  2. Ranch garages run the vent up into the eave, and that long duct traps lint until the heat quits.
    from $130
  3. Hard water leaves scale on the heating element, so a full cycle stops drying and starts filming.
    from $150
  4. Remodeled kitchens here often include a dual-zone unit, and a warm compartment during a heat wave is urgent.
    from $150
  5. Ice maker repair
    Plumbed refrigerators scale their fill valve on valley water and start making hollow, cloudy cubes.
    from $150

Ice maker repair in Encino: questions we get

We have a built-in refrigerator that ices up. Is that a repair or a replacement?

Almost always a repair. Ice on the coil usually points to a defrost heater, a thermistor or a torn door gasket, and we tell you the part cost before we open the panel.

Our ice maker keeps producing hollow, cloudy cubes. Why?

Valley water is hard and the fill valve scales up, so the mold never fills properly. We replace the valve and flush the line, then check whether the supply needs a filter.

A technician in Encino today

Flat price agreed before the ice maker is opened, and the diagnostic comes off the bill.

Call nowBook online