Dryer repair cost in Los Angeles

Most jobs $130–$400Typical $270Prices reviewed August 2026

10%

off labor

when you book online

Labor only. Parts are not discounted.

Tell us what broke

We'll call or text about this repair. Nothing else.

State registered and insured Same-day, 2-hour window Diagnostic credited

Fixing a dryer in Los Angeles runs $130 to $400, and $270 is about the middle. An electric dryer that needs a belt or a fuse sits low. A stacked gas pair tucked in a hall closet, lifted down before the burner assembly can even come out, is what climbs to the top.

Biggest price swing. Gas or electric, and where the machine sits. An electric dryer in a garage with room behind it is the easy case. A gas stack in a second-floor closet needs the gas shut off, the unit walked out, and the vent run checked before anything goes back together.

Dryer repair in LA
$130–400
Typical job
About $270. Your flat price is agreed before anything is opened.
Diagnostic
$70. It comes off the bill when you approve the repair. If you decline, it is all you pay.
Warranty
90-day parts & labor on the work we did.

Prices reviewed August 2026. You approve the flat number before anything is opened.

What changes a dryer repair quote

Gas or electric, plus where the dryer is installed, move the price furthest. The other tiles are about which part sits behind the symptom.

  • Gas vs electric heat source
  • Stacked or closet-mounted install
  • Heating element vs thermal fuse
  • Belt, drum rollers and blower wheel
  • Vent duct blockage
  • Moisture sensor and control board
  • Pedestal removal on front loaders

Typical jobs and what they cost

JobPartPart costTimeTotal
Dryer not heatingHeating element and thermal fuse$40-$110About an hour.$180-$280
Dryer not dryingSemi-rigid transition duct$15-$35About an hour.$160-$260
Dryer making noiseDrum roller kit with axles$20-$60About an hour and a half.$180-$280
Dryer won't startThermal fuse$10-$30About an hour.$180-$300
Dryer shuts off earlyNo part, adjustment or cleaning-About 30 minutes.$150-$220
Burning smell from the dryerNo part, adjustment or cleaning-About two hours.$200-$300
Dryer drum not turningDrive belt and idler pulley$15-$40About an hour.$180-$280

Typical ranges for these jobs in LA, not quotes from past invoices. Your flat price comes after the diagnostic.

What each end of the range buys

A single appliance start relay
The straightforward visit
A thermal fuse, a drum belt or an idler pulley covers the bottom of the range. For a belt, the drum comes out, the new belt routes around the motor pulley, and the lint bed under the cabinet gets vacuumed while everything is open.
A fan motor, a control board and a door gasket laid out together
The long one
Gas models run higher. A bad igniter, flame sensor or safety coil means gas off at the valve before anything else happens, and the burner assembly comes out as a unit. A stacked pair in a hallway closet costs more again, because the dryer has to be lifted down and walked out before the back panel is even visible. Worst case is a cracked blower wheel or a seized rear bearing, which takes most of the machine apart.

Repair the dryer or replace it

Belts, rollers and heating parts are cheap, so a dryer up to about twelve years old is worth repairing. If the drum is rusted through or the bearing has chewed into the rear housing, buy new.

A burning smell isn't automatically a death sentence. It can be lint scorching where it has packed in around the heater and blower, which takes a two-hour teardown and cleaning with no part, $200 to $300. Whirlpool-group dryers carry the lowest parts prices we see, so inside twelve years fixing one nearly always beats buying new.

Where to go next

Other appliance repair costs

Same flat-rate approach, different machine. Each guide has its own range and its own price drivers.

Dryer repair cost: questions we get

Do gas dryers cost more to repair than electric ones?

Yes, on the heating side. Gas gets shut off at the valve first, and when the igniter, the flame sensor or a safety coil fails, the whole burner assembly is removed as one piece. An electric dryer with an open element is simpler. That job, element plus a fresh thermal fuse, costs $180 to $280 and takes about an hour.

Why does my dryer's thermal fuse keep blowing?

Most likely your vent is restricted and the dryer can't shed the heat it makes. The fuse is a one-time safety device, so fitting another into a choked dryer only buys a few loads. The actual repair is cleaning the whole duct run, dryer to exterior hood. With the dryer running, hold a hand at the outside hood. Weak airflow there means the duct.

Does a stacked dryer in a closet cost more to fix?

It does, because of the lifting. In a hallway closet the dryer comes off the washer and gets walked out before its back panel is even in view, then it goes back up afterward. On a gas unit the supply is shut off as well, and we check the vent run before everything is put back together.

How much does a dryer belt and idler pulley replacement cost?

Figure $180 to $280 and roughly an hour, with parts at $15 to $40. Replace the idler pulley along with the belt, because an idler with a flat spot drags and wears belts out. While the cabinet's open we vacuum out lint, spin the drum by hand to check it runs true, then close up and test it empty.

Why does my dryer thump once every time the drum turns?

That rhythm points at worn drum support rollers with flat spots. We swap rollers and axles together as a set, $180 to $280 for about 90 minutes, since they've all logged the same hours. The drum must come out to reach them, so we clear lint from around the heater and blower while it's apart.

Find out what your dryer will actually cost

The $70 diagnostic buys you the real fault and a flat number for the repair. Approve the work and it comes off the bill.

Call nowBook online